Anti-Reflection Coatings Explained: V-Coat, Broadband and More

Every uncoated glass surface reflects about 4% of the light hitting it. In a system with several lenses or filters, those small losses compound and create ghost images and stray light. An anti-reflection (AR) coating uses destructive interference to cancel most of that reflection, raising transmission from roughly 92% to 99% or more per surface.
The physics is elegant: a thin film roughly one quarter of a wavelength thick creates two reflections that are 180° out of phase, so they cancel. Because cancellation depends on wavelength, a single-layer coating works well only near one design wavelength — usually green, where the eye is most sensitive.
A V-coat is a single or few-layer design tuned for very high transmission at one specific wavelength, with a characteristic 'V' shaped reflectance curve. It is ideal for a laser line — for example a 1064 nm Nd:YAG system — and is commonly applied to laser optics and windows.
A broadband AR coating uses multiple layers to keep reflection low across a wide range, typically 400–700 nm for the visible or a defined NIR band. It is the right choice for imaging systems, detectors and white-light applications where many wavelengths matter at once. Our double-sided AR quartz glass uses a broadband coating on fused silica.
Substrate choice interacts with the coating. Fused silica, SCHOTT glass and Corning glass each have different refractive indices, so the coating recipe must be designed for the specific substrate. An AR coating optimised for BK7 will not perform the same on high-index flint glass.
Angle of incidence matters too. As the beam tilts, the effective optical thickness of the layers changes and the reflection band shifts toward shorter wavelengths. If your optics sit in a converging beam or at 45°, specify the coating performance at that angle rather than at normal incidence.
Hard versus soft coating is a practical decision. Ion-assisted or plasma-assisted deposition produces dense, hard films that survive cleaning and humidity — essential for production instruments. Conventional thermal evaporation gives softer films that are cheaper but scratch more easily.
AR coatings are used across our range, not just on windows. Shortpass filters such as the SP460+AR shortpass filter add an AR layer on the back surface to suppress secondary reflections that would otherwise reduce contrast in a fluorescence system.
When specifying an AR coating, give your supplier the wavelength range, incidence angle, polarisation, substrate material, required reflectance and environmental conditions. Ask for a measured curve — a quote that only states 'AR coated' without numbers is not enough.
If you need a coating tailored to an unusual wavelength or substrate, send us your parameters. We design, deposit and measure custom AR coatings, and can apply them to standard optics or your supplied parts.